Tab Content
  • SENC's Avatar
    Yesterday, 08:41 PM
    SENC replied to a thread 65 Lotus Seven S2 in Member Rides
    Dizzy was pretty clean,, but could use some new points. Also replaced the HT leads after finding one with much higher resistance than the rest...
    86 replies | 7240 view(s)
  • SENC's Avatar
    05-24-2020, 09:22 PM
    SENC replied to a thread 65 Lotus Seven S2 in Member Rides
    Thanks guys. I'm back to focusing on the timing - starting with dwell, which was a bit lower than expected when I checked. I'm going to pull...
    86 replies | 7240 view(s)
  • SENC's Avatar
    05-24-2020, 07:21 PM
    SENC replied to a thread Coronavirus in Off Topic
    214 replies | 14205 view(s)
  • SENC's Avatar
    05-24-2020, 08:11 AM
    https://www.finn.no/car/used/ad.html?finnkode=179875681&taid=Share_ad_facebook&fbclid=IwAR24bUu0QUpu1dTG6Cn8u9ozSy_D9HqCegkpXuymS_izCDQUnX6RX1qIJpY
    2466 replies | 710036 view(s)
  • SENC's Avatar
    05-23-2020, 06:29 PM
    SENC replied to a thread 65 Lotus Seven S2 in Member Rides
    Good results on compression test. Got close on tuning, but still have some afterfire. I know the scorcher/bosch distributor is a good one, but I...
    86 replies | 7240 view(s)
  • SENC's Avatar
    05-22-2020, 03:52 PM
    SENC replied to a thread 65 Lotus Seven S2 in Member Rides
    Apart and cleaned up. You have to admire the simplicity!
    86 replies | 7240 view(s)
  • SENC's Avatar
    05-21-2020, 08:25 PM
    SENC replied to a thread 65 Lotus Seven S2 in Member Rides
    Wow, that is beautiful design and work! My car originally came with an oil cooler (partially visible in a 1966 photo). The oil radiator that used...
    86 replies | 7240 view(s)
  • SENC's Avatar
    05-20-2020, 08:16 PM
    SENC replied to a thread 65 Lotus Seven S2 in Member Rides
    Thanks Ron, I used a cometic gasket and know I'll need to tighten after the first few heating/cooling cycles, but hope it will be ok afterward. Will...
    86 replies | 7240 view(s)
  • SENC's Avatar
    05-18-2020, 01:29 PM
    SENC replied to a thread 65 Lotus Seven S2 in Member Rides
    I've been told elsewhere that the breather I have is an early one and should have an elbow on top of it that terms in a pipe (originally to the...
    86 replies | 7240 view(s)
  • SENC's Avatar
    05-17-2020, 04:15 PM
    SENC replied to a thread 65 Lotus Seven S2 in Member Rides
    Thanks Dingo. I've purchased a set of stubby ball-end L-wrenchs for next time No, not ceramic coated, just a coat of high-temp paint. ...
    86 replies | 7240 view(s)
  • SENC's Avatar
    05-16-2020, 11:27 AM
    SENC replied to a thread 65 Lotus Seven S2 in Member Rides
    Whew, re-installing the carbs/intake manifolds and exhaust manifolds on the pre-crossflow is a booger! I used hex key bolts rather that studs, but...
    86 replies | 7240 view(s)
  • SENC's Avatar
    05-10-2020, 09:31 PM
    Geez, a bunch of stalkers around here. Isn't there a law? :smilielol5::smilielol5::smilielol5:
    7 replies | 401 view(s)
  • SENC's Avatar
    05-06-2020, 08:46 PM
    SENC replied to a thread Coronavirus in Off Topic
    214 replies | 14205 view(s)
  • SENC's Avatar
    05-03-2020, 04:00 PM
    SENC replied to a thread 65 Lotus Seven S2 in Member Rides
    He is the oldest son, still a toddler at the time. As I somewhat expected, drilling 1/32" holes through stainless is above my capability and...
    86 replies | 7240 view(s)
  • SENC's Avatar
    05-02-2020, 07:55 PM
    SENC replied to a thread 65 Lotus Seven S2 in Member Rides
    Carburetors cleaned up and back together, with only 1 additional surprise. I somehow missed on disassembly that 1 of the air correctors in the main...
    86 replies | 7240 view(s)
No More Results
About SENC

Basic Information

About SENC
Location:
SE NC

Signature


Henry
1965 Seven S2
1969 Elan S4

Statistics


Total Posts
Total Posts
66
Posts Per Day
0.29
General Information
Last Activity
Today 07:52 AM
Join Date
10-14-2019
Referrals
0