Tab Content
  • papak's Avatar
    06-01-2020, 10:08 PM
    papak replied to a thread Rear Exhaust Mount in General Tech
    You could cut a valve spring in half with a cutoff wheel and sandwich it between two fender washers and run a through bolt through the whole...
    11 replies | 670 view(s)
  • papak's Avatar
    05-27-2020, 03:02 PM
    How much do you figure it will cost to polish out the aluminum? 22” wide seats will be a very tight fit (if at all). Try Kirky drag seats (same as...
    15 replies | 510 view(s)
  • papak's Avatar
    05-25-2020, 04:09 PM
    papak replied to a thread T-9 issue in General Tech
    The box is finally back together and all gears engage! One of the last frustrations was getting the centering spring correctly mated to the centering...
    7 replies | 625 view(s)
  • papak's Avatar
    05-24-2020, 03:39 PM
    What is the most effective solvent for removing Hylomar sealant? It's been many years since my Formula Ford days and I can't recall anything other...
    1 replies | 97 view(s)
  • papak's Avatar
    05-09-2020, 01:12 PM
    papak replied to a thread Rear Exhaust Mount in General Tech
    I just a replacement from Aircraft Spruce. I’m hoping an “aircraft quality” mount will last longer. You really have to minimize the offset.
    11 replies | 670 view(s)
  • papak's Avatar
    05-09-2020, 01:10 PM
    I spoke with Tom the other day. He is doing well. Things are moving along.
    8 replies | 668 view(s)
  • papak's Avatar
    05-08-2020, 09:56 PM
    papak replied to a thread 2.0L Duratec Rebuild in General Tech
    That looks pretty much as I remember it. I know that I sent them a couple of pictures of what I had and they took care of the rest. They were great...
    131 replies | 9588 view(s)
  • papak's Avatar
    05-08-2020, 04:56 PM
    papak replied to a thread T-9 issue in General Tech
    When I got it back together, a couple of things didnít look right and there was a bit of sludge in the bottom of the main case so I decided to pull...
    7 replies | 625 view(s)
  • papak's Avatar
    05-08-2020, 04:23 PM
    papak replied to a thread 2.0L Duratec Rebuild in General Tech
    As I recall, the kit included the wedge and a new windage cover, several o-rings and a short section of pipe. A couple of the rings were square...
    131 replies | 9588 view(s)
  • papak's Avatar
    05-08-2020, 01:29 PM
    papak replied to a thread 2.0L Duratec Rebuild in General Tech
    I have the older Raceline wetsump. The fellow I acquired it from had converted to the Raceline dry simp stop om his 2.0l Duratec. I contacted...
    131 replies | 9588 view(s)
No More Results
About papak

Basic Information

About papak
Location:
Los Angeles

Statistics


Total Posts
Total Posts
256
Posts Per Day
0.13
General Information
Last Activity
Yesterday 10:12 PM
Join Date
12-06-2014
Referrals
0