Activity Stream

I like the concept and the fact they even went to the effort of fitting the Jenvey Heritage Throttle Bodies to maintain the old school vibe under...

Josh at Rocky Mountain Caterham said there was a new announcement coming today so I would guess that this is what he was talking about and he will be...

Peterbilt truck https://dallas.craigslist.org/ndf/pts/d/denton-ratrod-vintage-peterbilt-guage/7104511450.html

What car did that come off? Obviously pre-war...

Removed duplicate entry to post above.

Yes, you should be able to access the tunnel by removing the center arm rest. I removed mine to repair the covering, which had come unglued. As I...

LOL...the planes I fly don't have that many gauges.

Remember, the CDC advise is too stay 6 feet apart from each other. OR as we say in Texas, 12 tacos apart.

Thanks. But isn't the driveshaft fully surrounded by frame members, so that even if I disconnected at the u-joint, I wouldn't be able to get it out...

Definitely not related. Plastic dowels came out of the pantry. The Rover K series engine head gasket issues came from using panties. Both leak you...

There may be an access panel around the shifter under the carpet. Check the rear u-joint, you may be able to disconnect it from the drive shaft or...

The plastic dowels on the early k series did cause head gasket issues. They were later replaced with metal ones. That helped correct that issue....

I went through that hassle too. It was easier to find and order the Duratec tappets from a Mazda dealer. Ford dealers didn't even seem to know what...

Can I take the driveshaft out without removing the differential? Can I access the center tunnel from above, if I remove the center armrest?

If the line is failing sometimes they will "shed". You may want to check your float bowls and toss in a new fuel filter.

I went through that chasing various tappets. I had to use various online sites and cross reference until I could figure out how the p/n system worked...

Rover K series engine used plastic dowels. It was easier to replace those - there was usually something in the pantry that could substitute.

Earlier I mentioned the dowel pins that locate head to block were removed when the deck was blocked. I have the originals, but they were damaged...

Feet, fella....I know they're both still there...that's all that matters.:jester:

Pour a glass for me please! The reason the braided line is likely leaking is that the inner rubber is not fuel safe. So over time it decays and...

Shane - when did you last see your feet? A decade ago? To that point, was that when you last saw your old fella?

Done!